![]() ![]() The Interface Software Doesn't Start After PMDG SDK License Acceptance If you wish to apply the uiautomationcore.dll fix, simply copy the corrected file into the FSX directory and leave the existing file in the Windows\System32 intact if you didn't replace it otherwise replace the changed file with the original version to get GIT working. Although this fix is valid to resolve FSX crashes, the advice to replace the file in the Windows sub-directory is wrong because it then affects all the software on the system and causes problems. This occurs when a system has had its uiautomationcore.dll file replaced in the Windows\System32 directory. The Interface Software Crashes After PMDG SDK License Acceptance The issue is a Windows problem, not a GIT problem. If the GIT window overlaps your flight simulator window then display issues occur that disable the ability to show and display drop down lists/combo boxes etc. Please follow all the steps in the Installation section of the online user guide.ĭevices cannot be selected on device tabs The Goflight Interface Module.dll has not been loaded.Your flight simulator is not in sim mode. Sim mode is when an aircraft is loaded and showing its virtual cockpit or 2D panels.This is caused by either or both of the following: The reason they stay disabled until sim mode is active is due to an issue regarding some Lvars only becoming available in Sim mode. Your flight simulator is not in sim mode. Sim mode is when an aircraft is loaded and showing its virtual cockpit or 2D panels. You need the latest GoFlight Drivers (version 2.26.5). ![]() If the issue remains, try the hardware on a Windows 7 (or below) PC to check the hardware isn't faulty and if it is OK, contact GoFlight Inc for support. If this does not fix the problem, remove ALL GoFlight hardware and repeat then reconnect the GoFlight hardware. If the problem remains, use Windows Explorer to go into the GoFlight drivers directory, right click on Windows8Fixer.cmd and select Run As Administrator. Note that ALL connections in between the GoFlight hardware and the PC must be USB 2 or USB1. If you are running Windows 8 or Windows 10 and the LED's and Displays are not working, double check that you only have USB2 or USB1 ports connected to the GoFlight hardware. How To Load Aircraft Configurations From The Downloads Section If you are not logged in, you will be promoted for your login credentials that you created. Click the Downloads tab and you will see your User Key listed next to your order and download options. If you are logged in, 3 tabs will be displayed: Orders, Downloads and Addresses. Where Is My User Key and/or Software Download? ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |